Fishing Boat Launch Procedures

After you arrive at your favorite boat launch ramp, there are still many steps which you must take before you can begin fishing. Many procedures must be undertaken before you can stop working and start having fun. These steps are mandatory in order to have a safe launch and a safe trip. They range from the common sense to those which may be easily overlooked.

The following steps all take place once you arrive at the ramp of your choice, whether it is at a state park, great lake, or any other body of water such as another lake or river. The first launch procedure, as well as the most basic first step, is to remove all straps and rigging connecting the boat to the trailer, excluding the winch line connected at the front of the boat. The next launch procedure you must undertake is to install the boat plug to ensure water does not consume the boat once it enters the water and it is too late. The plug can easily be overlooked due to its small size, but forgetting this key step can have very disastrous results. The next launch procedure to address is to ensure protection of your prized motor. Tip the motor up so that it doesn't catch on the cement of the ramp and damage your motor and cause you to lose money and a great day of fishing. While still at the rapm before entering the water, disconnect the trailer lights, unlock the boats storage hatches, and put the keys (if needed) into the ignition of your boat. These are the entire launch procedures which are required before you or your boat even get wet.

The next launching procedure you must engage in is backing your boat of choice into the water and guiding it using ropes to the nearby dock. Once the boat is at the dock, board the boat and lower the motor into the water. You will then need to start the motor in neutral to ensure that all components are in working order before you are in the middle of the lake. Now is also the time to remove your truck and trailer from the water and park them in the adjacent parking lot until you return from your fishing expedition. This concludes all of the procedures you must complete to get your boat in the water and to make sure everything is in good condition. Next you will complete final launch procedures before casting away from the dock.

The first launch procedure you must complete before you're able to cast your first line is to put on your life jackets. This step is the most important of any listed in this article as it ensures both your safety as well as the safety of all those accompanying you on your fun-filled day of fishing. One everyone has boarded the boat and properly attached their life jackets, it is time to move on to the next launch procedure, installing and setting your fish finder. This process is typically very easy and allows you to have the most time fishing once you leave the dock. Another safety measure is next on our list. This one involves booting your GPS unit (if you have one) and storing the dock as a return waypoint. If you do not have a GPS, make sure you have a compass and know the direction to return. Also, make sure your navigational lights are hooked up and turned on if needed. Lastly, fill your live well and set sail.

Preparing a boat to launch can be a daunting task, especially if you are unsure of all the steps involved or often forget important launching procedures. However, by preparing ahead of time as well as ensuring you have all the supplies you need before hand can make the process a lot simpler for you and everyone. Following a guide such as this one can make your fishing trip more enjoyable, even if the fish aren't biting.