How to Frost Glass

Frosting can add a whole new look to boring glass tables or other furniture. This technique can also add a soft design to your windows without blocking out natural light. Following these directions are easier than etching and will give you the same look. Here are a few things you will need to gather before beginning your project. You will need:

Glass (table top, window..etc)
Craft paper
Scissors
Clear contact paper
Versa tool with stencil cutting tip
Plastic pan scraper
Krylon frosted glass finish
Masking tape
Krylon surface protector spray
Artist knife

First, clean your glass and make sure it is completely dry. Cut a piece of contact paper to cover the entire surface of the glass. Smooth it in place using a scraper or burnishing tool to press out any air bubbles. Make sure you place edge to edge and cover the entire surface.

Next cut a template the size of your surface using craft paper. This will be your template for your design. Fold your template into quadrants. The creases will divide the template which will help you determine your stencil placement. Draw or photocopy a stencil design onto your craft paper template.

After you have created a design, place the template with design side up onto glass. Glass should also have contact paper side up. Line up corners and tape down firmly to hold into place. Use the walnut hollow creative versa tool with a stencil cutting tip to cut stencil design from contact paper. Peel away the cutout shapes as you work. Take your time and remember to remove the cutout shapes slowly.

Once you complete entire design make sure all cut edges are adhered firmly to glass. This will prevent spray from leaking under the stencil. Apply the Krylon frosted glass finish. Hold the spray can about 12 inches above surface. Spray over the design area lightly. Apply several coats letting each coat dry between applications. Once you have applied several coats let project dry over night.

Finally, spray Krylon clear surface protector over the frosted area to prevent scratching the design. Let the surface protector dry completely before touching. When spray is dry you may apply more coats or peel the contact paper away from the glass. Peel the paper at an angle in a slow motion to prevent any scuffs or scratches. You should be able to see your design on the glass once the paper is removed. The frosted glass will leave a soft translucent design for you to enjoy.

Resources:

www.krylon.com

www.misterart.com